Outdoor DC Power Cabinet — HJ-SG-D02-01 / D02-02
An integrated outdoor power cabinet for BTS and edge sites where a container will not fit: rectifier, lithium battery, controller and monitoring in one IP55 enclosure.
At a Glance
| Parameter | HJ-SG-D02-01 | HJ-SG-D02-02 |
|---|---|---|
| Enclosure | Single-bay outdoor cabinet, IP55 | Dual-bay outdoor cabinet, IP55 |
| DC output | −48 V DC, 200 A | −48 V DC, 400 A |
| Battery | 100 Ah LFP (4.8 kWh) | 200 Ah LFP (9.6 kWh) |
| Rectifier | 4 × 50 A, N+1 | 8 × 50 A, N+1 |
| AC input | 220/380 V, 50/60 Hz | 220/380 V, 50/60 Hz |
| Cooling | Heat exchanger + DC fans | Heat exchanger + DC fans |
| Mounting | Pole, wall or pad | Pad |
| Monitoring | Dry contacts + optional 4G gateway | Dry contacts + optional 4G gateway |
Where This Fits
Urban Densification
Rooftop and pole sites where there is no room for a shelter but the radio count keeps growing.
Edge and Small Cell
Low-power nodes that still need more than a few hours of ride-through.
Lead-Acid Replacement
Same footprint, same voltage window, four times the cycle life. No re-engineering of the site.
Design Notes
- Front access only — no side clearance needed, so cabinets can sit side by side
- Battery compartment thermally isolated from the rectifier compartment
- Anti-theft: concealed hinges, tamper switches, alarm on door open
- Optional C5-M coating for coastal and high-humidity sites
- All cabling enters from the bottom, gland plate supplied
Send Us Your Site Specification
Load in amperes, required autonomy hours, mounting type and ambient temperature.